2. If the soon-to-be used mounting hole doesn't have a standoff, move the pre-installed one
to that mounting hole.
Figure 2-21. Change the Standoff Position as Needed
3. Carefully insert the M.2 device into the M.2 slot at a 30-degree angle and lower the semi-
circle notched end onto the standoff.
Figure 2-22. Insert the M.2 Device and Press it Down
4. Tighten the standoff screw to secure the M.2 device into place. Do not overtighten so as
to avoid damaging the M.2 device.
Figure 2-23. Secure the M.2 Device
51
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
