NVMe Firmware Source
Use this feature to select the NVMe firmware to support system boot. The options are Vendor
Defined Firmware and AMI Native Support. The option of Vendor Defined Firmware is pre-
installed on the drive and may resolve errata or enable innovative functions for the drive. The
default option, AMI Native Support, is offered by the BIOS with a generic method.
Consistent Device Name Support
This feature controls the device naming for network devices and slots. The options are
Disabled and Enabled.
Compatibility device Support
Select Enabled if Supermicro add-on card AOC- SLG3- 2M2 is installed in SLOT3 of the
motherboard. The options are Disabled and Enabled.
Note: This feature is for SLOT3 only, and do not select Enabled if AOC-SLG3-2M2 is not
installed.
PCIe/PCI/PnP Configuration
CPU SLOT3 PCIe 5.0 x8 (IN X16) OPROM
CPU SLOT6 PCIe 5.0 x16 OPROM
CPU SLOT7 PCIe 4.0 x4 OPROM
M.2-C1 OPROM
M.2-P1 OPROM
SLIMSAS_8I Port0 OPROM
SLIMSAS_8I Port1 OPROM
Use this feature to select which firmware type to be loaded for the add-on card in this slot. The
options are Disabled and EFI.
Onboard LAN1 Support
Use this feature to enable or disable LAN1. The options are Disabled and Enabled.
Onboard LAN2 Support
Use this feature to enable or disable LAN2. The options are Disabled and Enabled.
Onboard LAN1 Option ROM
Select EFI to boot the computer using the EFI device installed on LAN port 1. The options are
Disabled and EFI.
Note: This feature is available when your motherboard supports onboard LAN ports.
112
X14SAE/X14SAE-F: UEFI BIOS
To Next Page
Loading...
