Supermicro X14SAE - Page 128

selected, the BIOS will search for a Dynamic Host Configuration Protocol (DHCP) server in the
network that is attached to and request the next available IP address for this computer. The
options are Static and DHCP.
Station IP Address
This feature displays the Station IP address in decimal and in dotted quad form (i.e.,
172.29.176.131). It is available for configuration when "Configuration Address Source" above
is set to Static.
Subnet Mask
This feature displays the sub- network that this computer belongs to. It is available for
configuration when "Configuration Address Source" above is set to Static.
Station MAC Address
This feature displays the Station MAC address for this computer. Mac addresses are six two-
digit hexadecimal numbers.
Gateway IP Address
This feature displays the Gateway IP address for this computer. This should be in decimal and
in dotted quad form (i.e., 172.29.0.1). It is available for configuration when "Configuration
Address Source" above is set to Static.
*****************************
Configure IPv6 Support
*****************************
IPv6 Address Status
This feature displays the status of the IPv6 address.
IPv6 Support (Available when "Update BMC LAN Configuration" is set to Yes)
Use this feature to enable IPv6 support. The options are Enabled and Disabled.
Configuration Address Source (Available when "IPv6 Support" is set to Enabled)
Use this feature to select the source of the IPv6 connection. If Static Configuration is selected,
note the IP address of IPv6 connection and enter it to the system manually in the field. If the
other two options are selected, the BIOS will search for a DHCP server in the network that is
attached to and request the next available IP address for this computer. The options are Static
Configuration, DHCPv6 Stateless, and DHCPv6 Stateful.
IPv6 Address ("Static," "DHCPv6 Stateless," or "DHCPv6 Stateful," depending on the
option you selected for "Configuration Address Source" above)
This feature displays the station IPv6 address. It is available for configuration when
"Configuration Address Source" above is set to Static Configuration.
128
X14SAE/X14SAE-F: UEFI BIOS