5. If the soon-to-be used mounting hole doesn't have a standoff, move the pre-installed one
to that mounting hole.
Figure 2-28. Change the Standoff Position as Needed
6. Carefully insert the M.2 assembly into the M.2 slot at a 30-degree angle and lower the
assembly onto the standoff.
Figure 2-29. Insert the M.2 Heatsink Assembly and Press it Down
7. Tighten the standoff screw to secure the M.2 heatsink assembly into place. Do not
overtighten so as to avoid damaging the M.2 assembly.
Figure 2-30. Secure the M.2 Heatsink Assembly
54
X14SAE/X14SAE-F: Component Installation
To Next Page
Loading...
