Sur-Gard System I - Option 00 D: Serial Printer Parity; Option 00 E: AHS Operations Time; Option 00 F: B32 Headers; Option 012: Heartbeat Timer

CHAPTER FOUR - OPTIONS: SYSTEM
33
SG-System I Operating Manual
4
Option 00D: Serial Printer Parity
Default (0)
This option determines the parity of serial port 2. ‘0’ represents no parity, ‘1’ represent odd parity, and ‘2’ represent even parity.
NOTE: The number of stop bits can not be changed and will always be 2.
NOTE: The SG-System I must be restarted for these changes to take effect
Option 00E: AHS Operations Time
Default (24)
Use this option to program at what time the AHS table will be saved to Flash. Backup will occur once every twenty-four-hours at the stated
time. When the backup operation is in progress a status message will appear on the LCD, above the time and date. A text message will be
sent to the printer when AHS backup starts, stops, or fails.
To set the time - on the hour - at which AHS backup will take place each day, take the following steps:
1. Navigate to Option 00E and press the Enter button.
2. The LCD will, if Option 00E has not previously been altered, mark the option’s status as ‘OFF’. Use the Up and Down buttons to
scroll to a time of day.
3. Select a time of day that you would like AHS backup to begin and press the Enter button. The unit will prompt you to save (Y?) or
decline (N?) your changes. Make the appropriate choice and press the Enter button.
Option 00F: B32 Headers
Default (00)
This option enables compatibility with MAS B32 Automation Software through TCP/IP. To enable this option, change the value to ‘01’.
NOTE: The SG-System I must be restarted for these changes to take effect
Option 012: Heartbeat Timer
Default (30)
Use this option to determine the time interval - measured in seconds - the heartbeat transmission is sent to Serial Automation and TCP/IP
port 1025. The heartbeat times is used to ensure that any communication through Serial Automation and TCP/IP is functioning normally
when there is no traffic from the receiver. Note that any traffic from the receiver will reset the heartbeat timer. Therefore, the heartbeat trans-
mission will be sent only if there is no signal sent during the time specified in Option 012.