Sur-Gard System I - Option 30 F: Receiver Number; Option 310: Line Card Number; Option 313: Transmitter Failure Debounce Time; Option 315: Transmitter Restoral Debounce Time

CHAPTER SIX - OPTIONS: IP
82
SG-System I Operating Manual
6
Option 30F: Receiver Number
Default (01)
The receiver number is used for sending signals to the central station software. Refer to the manuals for any central station automation soft-
ware being used to determine if there are any special requirements for this number. Also, ensure that there are no duplicate receiver numbers
used.
Option 310: Line Card Number
Default (03)
Use this option to provide each SG-System I line card with an identification code. A range of hexadecimal numbers from 01 - FE can be pro-
grammed in this option to identify your line cards.
Option 313: Transmitter Failure Debounce Time
Default (120)
The time, in seconds, for which a transmitter configured in supervised mode must be absent before a transmitter failure condition is reported.
Valid entries range from 30 - 65535 seconds.
NOTE: T-Link Absent Time should not be less than 90 seconds. For ULC Installations, Security Level A4, this option should
be programmed as 90 seconds. For UL Installations, this option should be programmed as 180 seconds.
Option 315: Transmitter Restoral Debounce Time
Default (60)
The time, in seconds, for which a transmitter must be present before it is registered in the Account Table and the transmitter restoral message
is sent. Valid entries range from 30 - 65535 seconds.
Option 319: Mask Transmitter Restoral
Default (OFF)
Use this option to enable or disable the reporting of the transmitter restoral condition on the SG-System I receiver. The default value is
appropriate in most situations, save those when the transmitter status is expected to fluctuate often due to, for example, system maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 31A: Mask Transmitter Failure
Default (OFF)
Use this option to enable or disable the reporting of the transmitter failure condition on the SG-System I receiver. The default value is appro-
priate in most situations, save those when the transmitter status is expected to fluctuate often due to, for example, system maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.