Sur-Gard System I - Option 173: Input;Output Sensitivity; Option 174: Equivalent Line Number; Option 175: Receiver Number; Option 176: Accounts 3;X - 4;X

CHAPTER FIVE - OPTIONS: CHANNELS 1 and 2
59
SG-System I Operating Manual
5
Option 173: Input/Output Sensitivity
Default (13)
This option serves a dual purpose, in that the DSP input sensitivity and the DSP output level are set. The lower nibble of the option will set
the output level; the high nibble will set the input sensitivity of the DSP.
NOTE: For more information, please contact DSC Technical Support.
Option 174: Equivalent Line Number
Default (00)
This option is used with the receiver number - see Option 175: Receiver Number on page 59 - for sending signals to the central station
automation software. These signals include trouble, alarm, etc. You can use this option to compensate if no DNIS number is being received
by the line card.
Option 175: Receiver Number
Default (01)
The receiver number is used to send signals to the central station software. Please refer to your central station automation software manuals
to determine if there are any special requirements for this number. In addition, check the numbers used for any other receivers in the station
to ensure that numbers are not duplicated.
Option 176: Accounts 3/x - 4/x
Default (00)
Table 22: Accounts 3/x - 4/x
Value Description Example
00
Disabled. If the alarm is reported in 3/1, 3/1 extended, BFSK, 3/2 or 3/8 ACRON
formats, a leading space will be placed in front of the 3-digit account codes.
1RRLLLsssssssAAAsXsssY[DC4]
01
If the alarm is reported in 3/1, 3/1 extended, 3/2 or 3/8 ACRON formats, a leading 0
(zero) will be placed in front of the 3-digit account codes.
1RRLLLssssss0AAAsXsssY[DC4]
02
Alarms communicated to the computer. If the alarm is reported in 3/1, 3/1 extended,
3/2 or 3/8 ACRON formats, a leading 0 (zero) will be placed in front of the 3-digit
account. In addition, a 0 (zero) will be placed in front of the 1-digit alarm code for
the above formats as well as 4/1 formats.
1RRLLLssssss0AAAsXss0Y[DC4]
04
If the panel is reported in SIA two leading 00 (zeros) will be placed in front of the 3-
digit account.
SRRLLL[#00AAA|Nri0/FH00]
05
If the alarm is reported in 3/1, 3/1 extended, 3/2 BFSK, SIA, 3.8 ACRON formats
then a leading 0 (zero) will be placed in front of the 3-dgit account.
06
If the alarm is reported in 3/1, 3/1 extended, 3/2 BFSK, SIA, 3.8 ACRON formats
then a leading 0 (zero) will be placed in front of the 3-dgit account and a 0 (zero)
will be placed in front of the 1-digit alarm code.