CHAPTER SIX - OPTIONS: IP
84
SG-System I Operating Manual
6
Option 31F: Mask Supervised Acc Exceeded
Default (OFF)
Use this option to enable or disable reporting if the account table limit is exceeded when a new account tries to connect to a SG-System I that
already has a full account table. The default value is appropriate in most situations, save those when the account table limit is expected to be
reached due to, for example, system testing or maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 320: Mask Transmitter Deleted
Default (OFF)
Use this option to enable or disable reporting if a T-Link account is deleted from a table. The default value is appropriate in most situations,
save those when multiple deletions are expected to be undertaken due to, for example, system testing or maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
Option 33A: Account Port
Default (3064) decimal; (0x0BF8) hexadecimal
Use this option to select a port number on which the SG-System I receiver will communicate with the T-Link Console software for adminis-
tration of the T-Link Account Table. You should ensure that a unique number is used for this option.
NOTE: The SG-System I must be restarted for these changes to take effect.
Option 340: Account Password
Default (CAFE)
Use this option set a password to restrict access to the receiver account table. In order to retrieve or modify the receiver account table, any
application that connects to it must have the same password. You must ensure that these applications and Option 340 share the identical
password. Applications that connect to the receiver account table include the following:
• T-Link Console
• SG Receiver Consoles
• Table Loader
• DLS (downloading software)
Option 344: DNIS Replacement of RRLLL
Default (00)
Use this option to instruct the SG-System I to output the RRLLL (receiver number and line number), or to replace the output of RRLLL with
DNIS from a DSC GSM transmitter, depending on the type of transmitter you have installed on your site. Both values will send the output to
the printer and to the automation software.
• 00 - SG-System I will output the RRLLL
• 01 - SG-System I will output the DNIS
To Next Page
Loading...
