Sur-Gard System I - Option 020: Mask UPS AC; Option 021: Mask UPS BAT; Option 024: Mask SG TCP;IP; Option 025: Mask SG Serial

CHAPTER FOUR - OPTIONS: SYSTEM
35
SG-System I Operating Manual
4
Sample printer message: 26 Nov 2003 16:41:25 - 26 Nov 2003-16:41:25-00/00-SG-01-000-0000--Printer Test Message
Option 020: Mask UPS AC
Default (ON)
Use this option to enable the UPS AC Shelf 1 trouble mask. If enabled, trouble conditions are not reported.
OFF - Condition reported
ON - Condition not reported (masked)
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 021: Mask UPS BAT
Default (ON)
Use this option to enable the UPS Battery Shelf 1 trouble mask. If enabled, trouble conditions are not reported.
OFF - Condition reported
ON - Condition not reported (masked)
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 024: Mask SG TCP/IP
Default (OFF)
Use this option to enable the SG TCP/IP trouble mask. If enabled, trouble conditions are not reported.
OFF - Condition reported
ON - Condition not reported (masked)
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 025: Mask SG Serial
Default (OFF)
Use this option to enable the SG Serial trouble mask. If enabled, trouble conditions are not reported.
OFF - Condition reported
ON - Condition not reported (masked)
See UL864 Programming Requirements on page 10.
Option 028: Mask TCP Printer
Default (OFF)
Use this option to enable the TCP Printer trouble mask. If enabled, trouble conditions are not reported.
OFF - Condition reported
ON - Condition not reported (masked)
See UL864 Programming Requirements on page 10.