CHAPTER SIX - OPTIONS: IP
85
SG-System I Operating Manual
6
Option 346: Account Digit Strip
Default (00)
Use this option to control the output of the account number set (from 1 to 9 digits) for the T-Link and the panel account code. The table below
lists the possible variations in output.
Example 1:
If Option 346 is set to 05, the T-Link account number set of ‘1234567890’ will be sent to output as 67890. The panel account code number
set will be sent to output as 1234567890.
Example 2:
If Option 346 is set to 02, the T-Link account number set of ‘1234567890’ will be sent to output as 90. The panel account code number set
will be sent to output as 1234567890.
Example 3:
If Option 346 is set to 08, the T-Link account number set of ‘0012345678’ will be sent to output as 12345678. The panel account code num-
ber set will be sent to output as 0012345678.
Option 347: SIM ID Output
Default (OFF)
Option 347 is available for use with the DSC GSM transmitter.
Use this option to send the SIM card number for the GSM transmitter account to the printer and the automation software. The output will
include the account number (up to 10 digits, depending on the status of Option 346) and the SIM card number (21 digits). The automation
software must support the protocol via the Sur-Gard output format for this option to work.
• OFF - the option is disabled
• ON - SG-System I will output the SIM card number
The automation software output will appear as follows:
sRRLLLAAAAAAAAAASSSSSSSSSSSSSSSSSSSSS
Table 35: Account Digit Strip
Value Output - T-Link Output - Panel
00 ten(10) digits as received
01 one(1) digit as received
02 two(2) digits as received
03 three(3) digits as received
04 four(4) digits as received
05 five(5) digits as received
06 six(6) digits as received
07 seven(7) digits as received
08 eight(8) digits as received
09 nine(9) digits as received
To Next Page
Loading...
