Sur-Gard System I - Option 31 B: Mask Transmitter Swap; Option 31 C: Mask Transmitter Unencrypted; Option 31 D: Mask Invalid Report; Option 31 E: Mask Unknown Account

CHAPTER SIX - OPTIONS: IP
83
SG-System I Operating Manual
6
Option 31B: Mask Transmitter Swap
Default (OFF)
Use this option to enable or disable the reporting of the T-Link swap condition on the SG-System I receiver. The default value is appropriate
in most situations, save those when the transmitter status is expected to fluctuate often due to, for example, system maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 31C: Mask Transmitter Unencrypted
Default (OFF)
Use this option to enable or disable the reporting of the T-Link sending an unencrypted event when the SG-System I receiver is expecting an
encrypted event condition on a SG-DRL3-IP receiver. The default value is appropriate in most situations, save those when a number of unen-
crypted events are expected to be sent due to, for example, system testing or maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 31D: Mask Invalid Report
Default (OFF)
Use this option to enable or disable the reporting of the invalid report condition. The SG-System I determines that the signal received is
invalid, a bad checksum, or an encryption key mismatch. The default value is appropriate in most situations, save those when a number of
invalid reports is exapected due to, for example, system maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.
Option 31E: Mask Unknown Account
Default (OFF)
Use this option to enable or disable the reporting of an unknown account report condition when the SG-System I receiver determines that it
is from an invalid account (not in the Account table). The default value is appropriate in most situations, save those when a number unknown
accounts are expected to be reported due to, for example, system testing or maintenance.
• OFF - Condition is reported.
• ON - Condition is not reported (masked).
NOTE: Refer to UL864 Programming Requirements on page 10 if changing the default setting.