OPERATION OF THE MACHINE
MA6 / MA8 - 1. Operation of the Machine - Rev.05 07-06
1
16
1.2.4.1 M 3xx Microscope
Before using the microscope make secure the TSA il-
lumination (control 210) is on and the BSA MICRO-
SCOPE key is off. Turn the SPLITFIELD switch
(control 214) on the front panel to left to get the TSA
image on the monitor.
401 BEAM SPLITTER TSA
This slide on right side of the microscope tube guide
the beam to the eyepieces, the monitor or both.
402 TSA Z-MOVEMENT knob
The fine movement works at any position in a range
less than on turn and with a low torque. Continuing
rotation increases the torque and enables the coarse
adjustment.
403 TSA Θ-MOVEMENT knob
Rotates the microscopes around the z-axis by turn-
ing the knob located in the upper right TSA micro-
scope front.
404 OBJECTIVE FOCUS FINE MANUAL knob
For the M 3xx without motorized focus, fine focus of
the left/right objective is possible by the left/right
knobs only.
405 OBJECTIVE X-SEPARATION knobs
The right/left objective can move independently in x-
direction by the big knobs located in the right/left side
of the TSA microscope body. Never turn this screw
when the CLAMPING SCREW is fixed.
406 CLAMPING SCREW
This has two functions. First it acts as a crank. Sec-
ond it is used to clamp a certain objective position.
Press that knob gentle toward the microscope body
and turn clockwise. To release turn in the opposite di
-
rection until it snaps out.
407 APERTURE TSA-Illumination
This right/left aperture at TSA-microscope front ad-
justs the illumination for the right/left TSA-objective
separately.
408 TSA SPLITFIELD switch
Located on the microscope front this switch selects
the left, right or both TSA-objective as source for the
eyepieces and monitor image.
409 Turret
Turn the knurled ring to move another objective in the
beam.
To Next Page
Loading...
