3-49 ENGINE CONTROL SYSTEM
Flywheel
• Clean flywheel and crankshaft mating surfaces with cleaning
solvent.
• Apply engine oil to flywheel bolt and washer before installing.
• Tighten flywheel bolt to specified torque.
09930-48720 : Flywheel holder
Flywheel bolt : 200 N
.
m (20.0 kg-m, 145 lb.- ft.)
z
@
INSTALLATION
Installation is reverse order of removal with special attention to
the following steps.
CKP sensors
Apply Thread Lock 1342 to the sensor mounting screws.
99000-32050 : Thread Lock 1342
h
To Next Page
Loading...
