6-41 POWER UNIT
Remove all conrod cap nuts 1 and conrod caps 2.
NOTE:
For proper assembly, mark cylinder number on all pistons,
conrods, and conrod caps, using quick drying paint.
NOTE:
To prevent damage to crank pin and cylinder walls, install a
piece of hose over threads of rod bolts.
Remove crankshaft.
Mark cylinder number on pistons using quick dry paint.
Push piston (with conrod) out through the top of cylinder bore.
NOTE:
• To prevent damage to piston rings, decarbon top of cylinder
bore wall before removing piston.
• Reassemble each conrod cap to its original position after
removing piston from bore.
Guide hose
To Next Page
