11-82 DF140 “K2” (’02) MODEL
When the housing is fully seated, tighten both retaining bolts
to the specified torque.
" Bearing housing bolt: 20 N
.
m (2.0 kg-m, 14.5 lb-ft)
RECHECKING DRIVESHAFT THRUST PLAY
Recheck the driveshaft thrust play.
Driveshaft thrust play:
Approx. 0.3 – 0.5 mm (0.012 – 0.020 in.)
\ 09951-09530: Gear adjusting gauge
"
CHECKING PROPELLER SHAFT THRUST PLAY
See the “GEARS - SHIMMING AND ADJUSTMENT/CHECK-
ING PROPELLER SHAFT THRUST PLAY” section on page
91.
\
SHIFT ROD GUIDE HOUSING
• Install the spring 1 and detent ball 2 into shift rod guide
housing.
• Apply Water Resistant Grease to the shift rod oil seal.
• Install shift rod 3 and washer 4 into the shift rod guide
housing 5, then secure it with the snap ring 6.
To Next Page
