DF140 “K2” (’02) MODEL 11-83
NOTE:
Before install the shift unit (Shift rod guide housing assembly),
be sure to put the horizontal slider in the neutral position.
• Apply Water Resistant Grease to the shift rod guide housing
O-ring.
NOTE:
Before install the shift unit (Shift rod guide housing assembly),
bring shifter yoke to the neutral position by turning shift rod
right or left.
Front
direction
Shifter yoke
Horizontal slider
Shifter yoke
• Install the shift rod guide housing assembly 7 by aligning
the shifter yoke with the groove in the horizontal slider, then
tighten three (
3
) housing bolts securely.
• Shift the shift rod from Neutral through Forward and Reverse to
check proper gear engagement.
• Apply enough Water Resistant Grease on oil seal before put-
ting seal cover 8 so that there is no space between them.
1. Horizontal slider
2. R-Gear bearing
housing
3. Shift rod center
2
3
1
To Next Page
