FRONT FORK AND STEERING 15-13
• Clamp the axle holder
2 with a vise. Protect the axle holder
with a rag when using a vise.
• Loosen the center bolt
3 completely with a 21 mm socket
wrench.
• Compress the outer tube by hands and install the conrod
holder (special tool) between the axle holder bottom
2 and
locknut
4.
$ 09910-20115: Conrod holder
• Hold the locknut with a wrench and remove the center bolt.
• Remove the push rod.
& WARNING
Clamping the axle holder too tight can damage it
which will affect riding stability.
Do not clamp the axle holder too tight.
To Next Page
Loading...
