Suzuki RM85L - Crankcase and Primary Driven Gear Reassembly

10-10 TRANSMISSION AND CRANKSHAFT
• Install the gear shift forks 1, 2, 3.
• Install the gear shift cam 3 and gearshift shafts 4, 5.
NOTE:
Turn the gearshift cam to the neutral position and confirm that
the driveshaft and countershaft turn without resistance.
CRANKCASE REASSEMBLY
• Install the new gasket 1 and dowel pins 2.
• Install the right crankcase half on the left crankcase half.
• Tighten the crankcase bolts.
 Crankcase bolt: 10 N·m (1.0 kgf-m, 7.3 lb-ft)
NOTE:
Tighten the bolts gradually and diagonally to guide the crank-
shaft into the bearing. If it is hard to tighten the bolts, separate
the crankcase and confirm that the transmission parts are
assembled correctly.
• Inspect the crankshaft for smooth movement.
• Apply grease to the oil seal’s lip.
• Install the spacer 1 to the crankshaft.