COOLING SYSTEM 12-5
WATER PUMP
WATER PUMP REMOVAL AND INSPECTION
• Drain engine coolant and transmission oil. (12-3 and 2-7)
• Remove the water pump cover 1.
• Remove the clutch cover. (7-3)
• Remove the snap rings 2 with snap ring pliers.
• Remove the impeller.
• Inspect the impeller for damage.
• Inspect the bearing for smooth inner race movement.
• Remove the snap ring and bearing with the special tool.
09916-44910: Valve guide driver
• Inspect the oil seal 1 for damage.
• Remove the oil seal 1 with the special tool.
09913-50121: Oil seal remover
To Next Page
Loading...
