Suzuki RM85L - Rear Wheel Bearing Removal; Rear Wheel Bearing Reassembly; Rear Wheel Installation

14-6 FRONT AND REAR WHEELS
REAR WHEEL BEARING REMOVAL
• Remove the dust seals and snap ring from the wheel hub.
• Fit the bearing remover into the wheel bearing.
 09921-20220: Bearing remover set
• Remove the bearings and spacer.
REAR WHEEL BEARING REASSEMBLY
• Apply grease to the bearings.
• Reassemble the spacer and bearings with the special tool.
 09941-34513: Bearing installer set
NOTE:
After reassembling the bearings, inspect the bearings for
smooth movement.
• Install the snap ring 1 at the left side (sprocket side).
• Install the dust seals and apply grease to its lips.
NOTE:
* The sealed cover of the bearing must face outside.
* Reassemble the left side (sprocket side) bearing first and then
reassemble the right side bearing.
REAR WHEEL INSTALLATION
• Reassemble the rear wheel and axle shaft.
• Adjust the drive chain slack. (2-13)
• Tighten the axle nut 1 to the specified torque.
 Rear axle nut: 72 N·m (7.2 kgf-m, 52.0 lb-ft)
Left Right
Clearance
Left Right