SHAFT
DRIVE AND
DIFFERENTIAL
4-19
•
Install
a
new spacer.
A CAUTION^
Replace
the removed spacer
with
a new one.
•
Tighten the differential drive bevel gear nut to the specified
torque.
[J] Differential drive bevel gear nut:
120 N m (12.0 kgf-m, 87.0
Ib-ft)
Measure
the bearing preload.
NOTE:
Before
measuring preload, be
sure
to rotate the gear
several
turns in both directions to
seat
the bearings.
EEffll Bearing preload
Standard:
30-70
Ncm
(3.0-7.0
kgf-cm,
2.6-6.1
Ib-in)
If
the
bearing preload
is not
within specification, tighten
the
gear nut
to
the specified torque
and
bring the preload within
specification.
H Differential drive bevel gear nut:
90-110
N m
(9.0-11.0
kgf-m, 65.0-79.5
Ib-ft)
A CAUTION
Make
sure to check the backlash and
tooth
contact
when changing the gear, bearing and/or outer race.
NOTE:
When
installing the universal
joint,
take care not to drop the
needle
rollers from the
cage.
A CAUTION
Replace
the removed C-ring
with
a new one.
To Next Page
Loading...
