T-Drill S-80 - Page 22

INSTRUCTION MANUAL
22

1 Tube material
Program informaon lines
cannot be altered on the main
screen, this is only informave.
These values are set in
machine sengs.
2 Tube length (feed table informaon)
3
Tube diameter: The actual diameter of the tube
to be collared
4 Tube wall thickness
5 Milling tool number
6 Drilling tool number
7 Collaring tool number
8 Trimming tool number
9 Milling me
10 Drilling me
11 Collaring me
12 Trimming me
13 Tool fasten me
14 Tool release me
15 Process me