PURESTRENGTH & BENCHES: Guida all'Assistenza Tecnica - rev. 4.1
Page 5.50
5.13.5. DISASSEMBLING THE SPRING
Figure 5.13-22
To facilitate the following operations:
1. Loosen the 4 screws of the upholstery (a) and
remove it from the eyelets using a 16mm
wrench.
When reassembling, pay attention to refit
the seat: the long side near the backrest.
Figure 5.13-23
2. Unscrew the 2 screws (b) using a 5mm
hexagonal key
Unscrew alternately the screw on the
right and on the left, not to overload
them.
Figure 5.13-24
3. Unscrew the screw (c) using a 4mm
hexagonal key.
4.
Remove the pin in the direction of the yellow
arrow (to the right).
Continued on following page
→
To Next Page
Loading...
