PURESTRENGTH & BENCHES: Guida all'Assistenza Tecnica - rev. 4.1
Page 5.11
5.1.10. DISASSEMBLING THE ADJUSTING FOOT
Figure 5.1-1
1. Turn the equipment over on one side, resting
it on a support to keep the foot raised off the
ground.
2. Remove the upper closing cap (a).
Figure 5.1-2
3. Force the tabs (b) out of the guide eyelets (c)
and remove the foot from the bottom.
Figure 5.1-3
4. To replace the pin (d), unscrew it until it
comes out from below using a 10mm
hexagonal key.
To reassemble the removed parts, carry out the
disassembling steps in reverse order.
To Next Page
Loading...
