PURESTRENGTH & BENCHES: Guida all'Assistenza Tecnica - rev. 4.1
Page 3.1
3. INSTALLING AND MOVING THE
EQUIPMENT
3.1. INSTALLATION SPECIFICATIONS AND REQUIREMENTS
For proper installation of the equipment, make sure that:
1. The equipment is installed on a level, vibration-free surface with a sufficient capacity to support
its weight plus that of the user.
2. The area is not dusty or sandy.
3. You have observed the temperature and humidity operating requirements indicated in paragraph:
2.3. “Ambient specifications”.
3.2. INSTALLING THE EQUIPMENT TO BE ASSEMBLED
The equipment is delivered on a wooden pallet, wrapped in nylon bag and packed in a carton. To
correctly install the equipment please follow the procedure detailed here below and in the user
manual.
CAUTION: special care should be taken when assembling onto the frame levers or other
components with bearings, as these can be easily damaged if the lever is not kept
properly aligned while clamping the screws and nuts. It is therefore very important to
check, when tightening screws and bolts, that the bearings, if any, are kept properly
aligned with each other.
To Next Page
Loading...
