Technogym PURESTRENGTH - Easy-Start Lever Group Disassembly (Part 2)

PURESTRENGTH & BENCHES: Guida all'Assistenza Tecnica - rev. 4.1
Page 5.52
5.13.6. DISASSEMBLING THE EASY-START LEVER GROUP
Figure 5.13-26
Carry out the procedure described in paragraph:
5.13.5. “Disassembling the spring”.
On both sides:
1. Unscrew the nut (a)
using a 17mm wrench
and the pin (b)
from the right side using a
8mm hexagonal key.
2. Release the lever (c).
Figure 5.13-27
3. Unscrew the screw (d) using a 4mm
hexagonal key and remove the pin from the
right side, in the direction of the yellow
arrow.
4. Release the lever (e).
To reassemble the removed parts, carry out the
disassembling steps in reverse order.