Technogym SELECTION 700 - Page 100

3. Remove the
screw [10a] with
the nut and the
washer [10b] as
shown at the side.
(TOOL: 17 mm
open end wrench
+ 8 mm hexagon
key wrench).
10b
10a
10c
4. Loosen the three
grub screws
[10c]. (TOOL: 4
mm hexagon key
wrench).
During the reas-
sembly, tighten
the grub screws
[10c]. (TOOL:
torque wrench-
tightening tor-
ques: 17 Nm
[12,5 lbf-ft]).
5. Remove the entire weight stack cable from the adjuster [8d].
SELECTION 700 Technical Service Guide
Rev. 2.0
- 102 - Document uncontrolled when printed