8d
2. Tighten the cable tensioner [8d] so
that the cable is taut.
Check the tension of the cable by carrying out a couple of repetitions with the minimum
weight.
3. Tighten the counternut [8c]. (TOOL: 2x22 mm open end wrench).
12.1.2 ADJUSTING THE TENSION OF THE CABLE WITH
DOUBLING PULLEY
This operation applies to MNAC- LEG PRESS, MNDC- MULTI HIP, MNEC- SHOULDER
PRESS, MNFC- CHEST PRESS, MNGC- VERTICAL TRACTION, MNHC- LOW ROW,
MNKC- DELTS MACHINE, MNNC- PECTORAL/REVERSE FLY.
If the weight stack cable is not taut, the problem is due to lengthening of the cable. Therefore, to
solve the problem you must use the cable tension adjustment system. For details see the following
procedure.
SELECTION 700 Technical Service Guide
Rev. 2.0
- 213 -Document uncontrolled when printed
To Next Page
Loading...
