Technogym SELECTION 700 - Disassembling the Cable at the Lever Side

8f
8g
5. Disassemble the
thrust ball bearing
[8f] and the bush-
ing [8g] as shown
at the side.
7.2.5.2 DISASSEMBLING THE CABLE AT THE LEVER SIDE
1. Perform all the steps described in the previous paragraph “6.2.5.1 Disassembling the cable
at the weight stack side”
10
2. Disassemble the
guard [10] re-
moving the ve
screws highlight-
ed in red. (TOOL:
4 mm hexagon
key wrench).
SELECTION 700 Technical Service Guide
Rev. 2.0
- 101 -Document uncontrolled when printed