11. TIGHTENING TORQUES - GREASE -
ADHESIVE & SEALANTS - BELT TENSIONING
11.1 CABLE CLAMP
This operation applies to all machines
6
Fig. 79
TIGHTENING TORQUE of cable clamp [6] on the nylon cable: 0,5 Nm [0,37 lbf-ft]
11.2 CABLE FIXING GRUB SCREWS
This operation applies to all machines
At least one end of the weight stack cable is xed to the wheel or to a stop by means of the dowel
screws highlighted in grey and circled in the gures below. The xing dowels must be carefully
locked down to prevent them from working loose and allowing the cable to come out, causing prob-
lems to the user.
SELECTION 700 Technical Service Guide
Rev. 2.0
- 195 -Document uncontrolled when printed
To Next Page
Loading...
