Technogym SELECTION 700 - Moving and Installing the Equipment; Installation Specifications; Lifting and Moving the Product

4. MOVING AND INSTALLING THE EQUIPMENT
4.1 INSTALLATION SPECIFICATIONS
1. Place the equipment on a at surface, where there are no vibrations and where the loading bear-
ing capacity is su󰀩cient for the weight to be supported, also taking into consideration the weight of
the user.
2. Carry out the installation operations indicated on the instruction sheet attached to each item of
equipment or during the distribution logistics course, available on E-Learning.
3. For details about equipment to be xed to oor/wall/ceiling, see Distribution Logistics documen-
tation, available on E-Learning.
3. The area is not dusty or sandy.
4. The area must have a large area of space all around the product and a space of at least 60 cm
on the side that accesses the product.
5. You have observed the temperature and humidity operating requirements indicated in para-
graph: “2.3 Environmental characteristics”
4.2 LIFTING AND MOVING THE PRODUCT
WARNING: Given the weight of the product, we recommend that it should always be lifted
by more than one person.
WARNING: When lifting the product, do not exert pressure against the weight stack guards.
Do not use the adjustment lever to try to move the equipment, because it may cause DAM-
AGE and become unstable.
WARNING: Move the product very carefully, because it may become unstable and tip over.
WARNING: Do not use the equipment with the castors tted. The castors are to be used
only for moving the equipment and must be removed before exercising on it.
Snap-on castors (optional) must be used to move the equipment. The castors for moving the equip-
ment snap on under the feet of the equipment, after it has been raised, and are held in place by
the special straps.
Raise the equipment on the weight stack side, using a pallet truck or fork-lift truck; and for greater
safety place a wedge under the frame to keep the equipment raised.
Insert the two xed castors rst on one side and then on the other side of the weight stack: t castor
stems (A) into the holes provided under the equipment feet, then push hard until they snap in.
SELECTION 700 Technical Service Guide
Rev. 2.0
- 75 -Document uncontrolled when printed