During the reassembly procedure of the paddings, apply medium strength threadlocker on the
screw [13c].
11.10 GREASE TO BE USED
This operation applies to MNOC- ABDUCTOR/ADDUCTOR
Fig. 94
Use generic grease on the pin during the reassembly procedure of the lever group.
14b
Fig. 95
Use generic grease in the position highlighted in red in the gure above, during the reassembly
procedure of the element [14b].
SELECTION 700 Technical Service Guide
Rev. 2.0
- 208 - Document uncontrolled when printed
To Next Page
Loading...
