7. To easily insert the lever
group in its position, re-
move the component [16]
rst, unscrewing the three
screws [16a]. (TOOL: 6
mm hexagon key wrench).
During the reassem-
bly, tighten the screws.
(TOOL: torque wrench-
tightening torques: 20
Nm [14.8 lbf-ft]).
8. Lift the lever group from the
lower part as shown at the
side and insert the group in
its position.
16a
16
SELECTION 700 Technical Service Guide
Rev. 2.0
- 121 -Document uncontrolled when printed
To Next Page
Loading...
