Technogym SELECTION 700 - Page 173

5. Remove the eccentric, the
pin and the spring (TOOL:
17 mm open end wrench).
During the reassembly pro-
cedure, insert the spring
and the pin from down.
Then tighten the eccentric
(17 mm open end wrench)
and ret the knob, its
screw (TOOL: 4 mm hex-
agon key wrench) and the
yellow plug.
For the reassembly pro-
cedure of the cam and
upper lever assembly,
make sure to align all the
spacers using a wrench
and position the puller
as shown in the gure.
Tighten the two screws of
the puller (TOOL: 17 mm
open end wrench) and fol-
low the aforementioned
instructions (see “8.2.3
Disassembling the upper
lever”)in the reverse or-
der.
SELECTION 700 Technical Service Guide
Rev. 2.0
- 175 -Document uncontrolled when printed