Technogym SELECTION 700 - Page 191

9. Assembly the element [E]
10. Insert the other end of the cable in [G] until you see all the grub screws.
11. Tighten the cable tie with the screws [F].
12. Ret the platform for pushing [D].
13. Ret the handle [C].
14. Ret the panel [A] behind the platform for pushing.
15. Ret the protective panel on the weight stack.
16. Select the maximum weight and check the held of grub screws that x the cable during an
exercise.
SELECTION 700 Technical Service Guide
Rev. 2.0
- 193 -Document uncontrolled when printed