9.2.3 DISASSEMBLING THE UPPER LEVER ...........................................................166
9.2.4 DISASSEMBLING THE CAM AND THE UPPER LEVER ASSEMBLY ............ 173
9.2.5 DISASSEMBLING THE HANDLE ......................................................................176
9.2.6 DISASSEMBLING THE HEADREST PADDING ...............................................177
9.2.7 DISASSEMBING THE SEAT PADDING ............................................................178
9.2.8 DISASSEMBLING THE SEAT SLIDING GROUP .............................................179
9.2.8.1 DISASSEMBLING THE LEVER .........................................................................183
10. PROCEDURES FOR DISASSEMBLY-REASSEMBLY AND REPLACEMENT
OF COMPONENTS- MNAC(LEG PRESS) .................................................... 187
10.1 NECESSARY TOOLS ..............................................................................................187
10.2 MNAC- LEG PRESS ................................................................................................188
10.2.1 DISASSEMBLING THE REAR PROTECTIVE WEIGHT STACK PANEL ........188
10.2.2 REPLACING THE WEIGHT STACK CABLE .....................................................189
11. TIGHTENING TORQUES - GREASE - ADHESIVE & SEALANTS - BELT
TENSIONING ...................................................................................................195
11.1 CABLE CLAMP ........................................................................................................195
11.2 CABLE FIXING GRUB SCREWS ...........................................................................195
11.3 FRAME GROUP .......................................................................................................198
11.4 LEVER GROUP ........................................................................................................ 200
11.5 PULLEYS .................................................................................................................. 203
11.6 GAS SPRING ...........................................................................................................204
11.7 LEVER FOR SEAT UNLOCKING ...........................................................................205
11.8 PLATE UNDER THE SEAT ......................................................................................206
11.9 PADDINGS ...............................................................................................................207
11.10 GREASE TO BE USED ...........................................................................................208
12. ALIGNMENT AND ADJUSTMENTS .............................................................. 211
12.1 ADJUSTING THE CABLE TENSION ...................................................................... 211
12.1.1 ADJUSTING THE TENSION OF THE CABLE WITH CRIMPED FITTING ..... 211
12.1.2 ADJUSTING THE TENSION OF THE CABLE WITH DOUBLING PULLEY ...213
12.2 ADJUSTING THE ECCENTRICS ..........................................................................214
12.3 LEVELLING THE EQUIPMENT ..............................................................................216
12.4 THE LEVERS OF DUAL-AXIS MACHINES ARE NOT ALIGNED ........................219
12.5 ADJUSTING THE POSITION OF THE LIMIT STOP BUSHINGS .......................219
13. PLANNED MAINTENANCE ...........................................................................221
14. LIST OF CHANGES FOR MANUAL REVISION ...............................................223
14.1 REVISION 1.0 ............................................................................................................223
SELECTION 700 Technical Service Guide
Rev. 2.0
- 9 -Document uncontrolled when printed
To Next Page
Loading...
