TECO N310 Series - preset Frequency function group

Chapter 4 Software Index
4-2
4.1.2 Operation Instruction of the keypad
v
*1: The inverter will flash the current setting of 05-03 (power supply voltage) after power up.
*2: 11-01, 11-02 determines the displaying of frequency, or line speed.
*3: It is not necessary to press ENTER key when stopped for modification. Refer to example 1, 2.
*4: Whether output current, output voltage, DC voltage is displayed or output PID is determined by
11-00 respectively.
Power On
Power Voltage (*1)
5 secon
d
s later o
r
afte
r
Enter operation signal, Press DSP to modify frequency.
Frequency/Line
Speed
HZ/RPM
Frequency/Line
Speed
HZ/RPM
Frequency/Line
Speed
HZ/RPM
(*3)
(*2)
Selecting the
p
arameter
g
rou
p
Selecting the
p
arameter
g
rou
p
FUN
FUN
Parameter Setting
☉
FUN
END
Output Voltage
DC Voltage
VOLT
Output Current
(*4)
AMP
● :LED fully Lit
: LED flashing
VOLT
Figure 4-2 Keypad Operations Sequence
Output PID