TECO N310 Series - Auto Run Function Group

Chapter 4 Software Index
4-19
12-07 Parameter Lock
0: Enable all Functions
1: 03-01~03-16 cannot be changed
2: All Functions cannot be changed Except
03-01~ 03-16
3: Disable All Function
0
12-08 Parameter password 00000~65535 00000
12-09 Copy Unit Reserved
13-Auto Run function group
Function
Code No.
Description Range/Code
Factory
Setting
Remarks
13-00 Auto Run( sequencer) mode selection
0: Disabled.
1: Single cycle.
(Continues to run from the
Unfinished step if restarted).
2: Periodic cycle.
(Continues to run from the
unfinished step if restarted).
3: Single cycle, then holds thespeed Of
final step to run.
(Continues to run from the unfinished
step if restarted).
4: Single cycle.
( starts a new cycle if restarted).
5: Periodic cycle.
( starts a new cycle if restarted).
6: Single cycle, then hold the speed of
final step to run.
( starts a new cycle if restarted).
0
13-01 Auto _ Run Mode Frequency Command 1
13-02 Auto _ Run Mode Frequency Command 2
13-03 Auto _ Run Mode Frequency Command 3
13-04 Auto _ Run Mode Frequency Command 4
13-05 Auto _ Run Mode Frequency Command 5
13-06 Auto _ Run Mode Frequency Command 6
13-07 Auto _ Run Mode Frequency Command 7
13-08 Auto _ Run Mode Frequency Command 8
13-09 Auto _ Run Mode Frequency Command 9
13-10 Auto _ Run Mode Frequency Command 10
13-11 Auto _ Run Mode Frequency Command 11
13-12 Auto _ Run Mode Frequency Command 12
13-13 Auto _ Run Mode Frequency Command 13
13-14 Auto _ Run Mode Frequency Command 14
13-15 Auto _ Run Mode Frequency Command 15
0.00 ~ 400.00 (Hz)
0.00
13-16 Auto_ Run Mode Running Time Setting 0
13-17 Auto_ Run Mode Running Time Setting 1
13-18 Auto_ Run Mode Running Time Setting 2
13-19 Auto_ Run Mode Running Time Setting 3
13-20 Auto_ Run Mode Running Time Setting 4
13-21 Auto_ Run Mode Running Time Setting 5
13-22 Auto_ Run Mode Running Time Setting 6
13-23 Auto_ Run Mode Running Time Setting 7
0.0 ~ 3600.0 (second) 0.0