TECO N310 Series - PID function group

Chapter 4 Software Index
4-8
00-06
Subsidiary Frequency
Command Source Selection
0:
Keypad
1: Potentiometer on Keypad
2:
External AI1 Analog Signal Input
3:
External Up/Down Frequency Control
4: Communication setting Frequency
0
00-07 Frequency Upper Limit (Hz) 0.01~400.00 50.00/60.00
00-08 Frequency Lower Limit (Hz) 0.01~399.99 0.00
00-09 Acceleration Time 1(Seconds) 0.1~3600.0 10.0 *1
00-10 Deceleration Time 1(Seconds) 0.1~3600.0 10.0 *1
00-11
Operation modes for external
terminals
0: Forward/Stop-Reverse/Stop
1: Run/Stop-Forward/Reverse
2: 3-Wire Control Mode-Run/Stop
0
00-12 Jog Frequency (Hz) 1.00~25.00 2.00 *1
00-13
Jog Acceleration Time (MFIT)
(Seconds)
0.1~25.5 0.5 *1
00-14
Jog Deceleration Time (MFIT)
(Seconds)
0.1~25.5 0.5 *1
1- External terminal digital signal input function group
Function
Code No.
Description Range/Code
Factory
Setting
Remarks
01-00 Multifunction Input Term. S1 0
01-01 Multifunction Input Term. S2 1
01-02 Multifunction Input Term. S3 2
01-03 Multifunction Input Term. S4 3
01-04 Multifunction Input Term. S5 4
01-05 Multifunction Input Term. S6
0: Forward/Stop Command
1: Reverse/Stop Command
2: Preset Speed unit 0 (3-02)
3: Preset Speed unit 1 (3-03)
4: Preset Speed unit 2 (3-05)
5: Preset Speed unit 3 (3-09)
6: Jog Forward Command
7: Jog Reverse Command
8:
Acc/Dec 2
9: Emergency Stop
10:
Base Block
11:
Speed Search
12: Energy Saving (V/F)
13:Main/Alt run Command select
14: Acc/Dec Disabled
15:
Up Command
16:
Down Command
17: Main/Alt Frequency Command select
18:
PID Function Disabled
19:
Integration Value Resets to Zero
20:
Reset
21:KEB function
22: Auto _ Run Mode
20
01-06
Multifunction terminal S1~ S6 confirm
the scan times
1~ 200 (mSec X 2 ) 10
01-07 Up/Down (Hz) 0.00~ 5.00 0.00