Telos TWOx12 - Page 130

TELOS TWOX12 USER’S MANUAL
DETAILED CONFIGURATION & REFERENCE
CHAPTER 7 118
i
ISDN TIP!
More on Telco Protocols: Guessing the Telco setting in Canada & USA:
• If you were given only a single phone number and no SPIDs try AT&T Cust
• If you were given 2 SPIDs with the format: 01+7 digit phone #+0 try AT&T Cust
• If you were given 2 SPIDs with the format: 01+7 digit phone #+000 or 01+7 digits
+011 try Natl.I- 1
• If you were given 2 SPIDs with the format: area code+7 digit phone #+4 digits
(for example 0101, 0100, 0111, or 1111) try Natl.I- 1. If that fails Try DMS Cust
• If you were given 2 SPIDs with the format: area code+7 digit phone #+1 digit (for
example 1, or 0) try DMS Cust. If this fails try Natl.I- 1
• If you were given 2 SPIDs with the format: area code+7digit phone #+2 digits (for
example 01, 11, 02, or 00) try DMS Cust. If that fails try Natl.I- 1
• If you were given 2 SPIDs with the format: area code+7digit phone #+3 digits (for
example 000,001) try Natl.I- 1. If that fails try DMS- Cust
• If you were given a single phone number and a single SPID with the format: of
01+7 digit phone#+0 try AT&T Cust (Do not enter this SPID)
• If you were given a single phone number and a single SPID with the format: of
01+7 digit phone#+00 try Natl.I- 1. If that fails try AT&T Cust
• If you were given a single phone number and a single SPID with the format: of
area code+7digit phone#+4digits (for example 0101, 0100, 0111, or 1111) Try
Natl.I- 1. If that fails try DMS Cust
w
IMPORTANT TIP!
After you enter (or change) your SPIDs or DN’s you must restart the system to use the
new information. Therefore, once you have entered SPID1, SPID2, DN1, and DN2
you should turn the power off and then back on. Then go to the ISDN status screen
and verify “Ready” status for both channels.
Slot A, Slot B, Slot C, Slot D
Your telephone interface cards are in slots A, B, C, & D. When the system is turned
on it scans the slots and the type of card is shown after the slot letter in this screen.
For instance: Slot A ISDN or Slot B POTS. If a given slot has a POTS interface no
configuration is required. If there is an ISDN interface an arrow is shown to indicate
that you must go to the sub menu and configure your ISDN. Clicking on one of those
arrows will show a screen like this: