Texi Fox 25 User Manual

DE
UNTERFADEN NACH OBEN BRINGEN
TABELLE MIT AUSWAHL VON NÄHGUTABHÄNGIGEN NADELN UND FÄDEN
1. Den Nähfuß heben
2. Halten Sie leicht den Faden an der Nadel und drehen das Antriebsrad oder
betätigen Sie zweimal die Taste der Nadelpositionierung. In dem Fall macht das
Antriebsrad eine Drehung.
3. Den Oberfaden aus der Nadel herausnehmen. Der Unterfaden wird über die
Stichplatte herausgenommen. Den Oberfaden leicht ziehen, gleichzeitig wird der
Unterfaden herausgenommen.
4. Die Enden von beiden Fäden unter den Nähfuß legen und ca. 10 cm ziehen.
Beachten Sie Nadeln mit entsprechenden Spitzen für genähten Sto zu benutzen.
9
KNOWING YOUR SEWING MACHINE
Balancing top thread tension
The top thread and the bobbin thread
should interlock in the center of two layers
of fabric in straight seams.
Set the desired number of the thread
tension dial at setting mark.
Loosen the needle thread tension by
moving the dial to a lower number.
Tighten the needle thread tension by
moving the dial to a higher number.
NOTE: In order to obtain better zigzag stitches, the top thread tension should be
slightly weaker than the bobbin thread tension. That means, the top thread
should appear slightly on the reverse side of the fabric, but the bobbin thread
c
annot appear on the top side of the fabric.
Drawing up bobbin thread
Raise the presser foot and hold the needle thread lightly
with you left hand.
Turn the hand wheel slowly towards you with your right
hand until the needle goes down and continue turning the
hand wheel until the take-up lever is at its highest
position.
Lightly draw up the needle thread forming a loop of the
bobbin thread.
Pull 15cm (6 inches) of both thread back and under the
presser foot.
③
②
9
KNOWING YOUR SEWING MACHINE
Balancing top thread tension
The top thread and the bobbin thread
should interlock in the center of two layers
of fabric in straight seams.
Set the desired number of the thread
tension dial at setting mark.
Loosen the needle thread tension by
moving the dial to a lower number.
Tighten the needle thread tension by
moving the dial to a higher number.
NOTE: In order to obtain better zigzag stitches, the top thread tension should be
slightly weaker than the bobbin thread tension. That means, the top thread
should appear slightly on the reverse side of the fabric, but the bobbin thread
c
annot appear on the top side of the fabric.
Drawing up bobbin thread
Raise the presser foot and hold the needle thread lightly
with you left hand.
Turn the hand wheel slowly towards you with your right
hand until the needle goes down and continue turning the
hand wheel until the take-up lever is at its highest
position.
Lightly draw up the needle thread forming a loop of the
bobbin thread.
Pull 15cm (6 inches) of both thread back and under the
presser foot.
③
②
9
KNOWING YOUR SEWING MACHINE
Balancing top thread tension
The top thread and the bobbin thread
should interlock in the center of two layers
of fabric in straight seams.
Set the desired number of the thread
tension dial at setting mark.
Loosen the needle thread tension by
moving the dial to a lower number.
Tighten the needle thread tension by
moving the dial to a higher number.
NOTE: In order to obtain better zigzag stitches, the top thread tension should be
slightly weaker than the bobbin thread tension. That means, the top thread
should appear slightly on the reverse side of the fabric, but the bobbin thread
c
annot appear on the top side of the fabric.
Drawing up bobbin thread
Raise the presser foot and hold the needle thread lightly
with you left hand.
Turn the hand wheel slowly towards you with your right
hand until the needle goes down and continue turning the
hand wheel until the take-up lever is at its highest
position.
Lightly draw up the needle thread forming a loop of the
bobbin thread.
Pull 15cm (6 inches) of both thread back and under the
presser foot.
③
②
Sto”yp Fadenstärke Nadelstärke
Leichte - dünne Georgette, Taft,
Seide etc.
Baumwolle #120 - 150
Seide #120 - 150
Synthetisch#120 - 150
70 – 80
Mittlere - Baumwolle, Leinen,
Satin, Samt etc.
Baumwolle #100 - 120
Seide #100 – 120
Synthetisch #100 - 120
80 – 90
Schwere - Gabardine, Tweed,
Denim, Kord etc.
Baumwolle #50 - 80
Seide #50 - 80
Synthetisch #50 - 80
90 – 100
Stretch - Strickwaren, Stretch,
Jersey etc.
Baumwolle #120 - 150
Seide#120 - 150
80 – 90
Texi Fox 2544

Texi Fox 25 Specifications

General

Brand	Texi
Model	Fox 25
Category	Sewing Machine
Language	English