EN
Lower the presser foot. Set needle in up position.
1. Lower the threader slowly and draw thread through guide and pull toward the
right.
2. Lower the lever as far as will go.
3. Rotate the lever to the rear of the machine and the hook pin will go through the
needle eye.
4. Draw thread through the hooked end.
5. Hold thread loosely and slowly return lever hook to original position. Hook will
turn and pass thread through needle eye.
6. Release the lever and pull thread out about 10 cm from needle eye.
CAUTION! Do not lower the threader lever while machine is operating.
NOTE: For smooth threading it is recommended you select straight stitching when
using the needle threader. Automatic needle threader cannot be used for double
needle.
NEEDLE THREADER
1 2 3
4 5 6
KNOWING YOUR SEWING MACHINE
Using automatic needle threader
Raise the needle to its highest position by rotating the hand wheel towards you.
1. Hook thread to thread guide as illustrated.
2. Pull down lever while holding the end of thread.
3. Rotate the lever to the rear of the machine.
4. Guide thread into hooked end and pull the thread upward.
5. Return the lever and needle will be threaded automatically.
6. Release the lever and pull thread away from you.
NOTE: For smooth threading it is recommended you select
straight stitching when using the needle threader.
NOTE: Automatic needle threader is only applic
able for presser foot.zigzag
Automatic needle threader cannot be used for double needle.
Texi Fox 25 71
To Next Page
Loading...
Need help?
General
