INTRODUCTION 2-4 Manual 0-4691
2
2.05 Power Supply Options and Accessories
Section 6, Parts Lists, provides catalog numbers and ordering information.
A. Single-Stage Air Filter Kit
For use with compressed air shop systems. Filters moisture and particulate matter from the air stream to at least
0.85 microns. This filter increases performance and improves consumables parts life.
B. Two Stage Air Filter Kit
For use on compressed air shop systems. Filters moisture and contaminants from the air stream to at least 5.0
microns. This filter is pre-assembled at the factory and needs only to be installed on the power supply.
C. High Pressure Regulators
High pressure regulators are available. The regulators are used to set the proper compressed air pressure.
NOTE
Regulators should not be installed with In-Line Air Filters.
D. Extended Work Cable with Clamp
As an alternative to the standard 20 ft / 6.1 m work cable & clamp on the power supply, a 50 ft / 15.2 m work cable
with clamp is available.
E. Multi-Purpose Cart
Rugged steel cart on easy-rolling rear wheels and front-mounted swivel casters. Provides maximum mobility for
the power supply and can also serve as a display cart. Top shelf is 12" / 305 mm x 20" / 508 mm. Steel handle is
30" / 762 mm high.
F. Wheel Kit
A kit with easy-rolling wheels, for maximum portability for the power supply.
G. Power Supply Dust Cover
A nylon canvas power supply dust cover with a water resistant finish
To Next Page
Loading...
Need help?
General
