Thermo 48i - Restore User Defaults; Password

Operation
Password
Thermo Electron Corporation Model 48i Instruction Manual 3-121
Restore User Defaults The Restore User Defaults screen is used to reset the user calibration and
configuration values to factory defaults. The restore default user is visible
only when the instrument is in service mode. For more information on the
service mode, see “Service Mode” earlier in the chapter.
• In the Main Menu, choose Service > Restore User Defaults.
•Press to warn and enable restore with .
•Press to overwrite all user settings with factory default values.
• Press to return to the Service menu or to return to the
Run screen.
Password The Password menu allows the user to configure password protection. This
menu is only shown if the password has been entered or the password has
not been set. For information on entering a new password, see “Enter
Password” below.
• In the Main Menu, choose Password.
• Use and to move the cursor up and down.
• Press to select a choice.
• Press to return to the Main Menu or to return to the Run
screen.
XXLO WCONCENTRATIONXXLO W
CO 15.80 PPM
SAMPLE 12:34 ALARMX
RESTORE USER DEFAULTS:


 RESTORE
ARE YOU SURE YOU WANT TO?x
PRESS ¨ TO CONFIRM RESTORE
RANGE AVG DIAGS ALARM