C-Link Protocol Commands
Communications Configuration
B-32 Model 48i Instruction Manual Thermo Electron Corporation
This command sets the internal clock (24-hour time). The example below
sets the internal time to 2:15 pm.
Note if seconds are omitted, the seconds default to 00.
Send: set time 14:15
Receive: set time 14:15 ok
Communications
Configuration
addr dns
This command reports the TCP/IP address for the domain name server.
Send: addr dns
Receive: addr dns 192.168.1.1
set addr dns address
This command sets the dns address, where address consists of four numbers
ranging from 0-255 inclusive, separated by “.”.
Send: set addr dns 192.168.1.1
Receive: set addr dns 192.168.1.1 ok
addr gw
This command reports the default TCP/IP gateway address.
Send: addr gw
Receive: addr gw 192.168.1.1
set addr gw address
This command sets the default gateway address, where address consists of
four numbers ranging from 0-255 inclusive, separated by “.”.
Send: set addr gw 192.168.1.1
Receive: set addr gw 192.168.1.1 ok
addr ip
This command reports the IP address of the analyzer.
Send: addr ip
Receive: addr ip 192.168.1.200
set addr ip address
This command sets the analyzer’s IP address, where address consists of four
numbers ranging from 0-255 inclusive, separated by “.”.
Send: set addr ip 192.168.1.200
Receive: set addr ip 192.168.1.200 ok
To Next Page
Loading...
