Thermo 48i - Measurements

C-Link Protocol Commands
Measurements
B-8 Model 48i Instruction Manual Thermo Electron Corporation
Measurements avg time
high avg time
low avg time
These commands report the averaging time in seconds when operating in
single range, or averaging time used with the high and low ranges when
operating in dual or auto range mode. The example below shows that the
averaging time is 300 seconds, according to Table B-2.
Send: avg time
Receive: avg time 11:300 sec
set avg time selection
set high avg time selection
set low avg time selection
These commands set the averaging time, high and low averaging times,
according to Table B-2. The example below sets the low range averaging
time to 120 seconds.
Send: set low avg time 8
Receive: set low avg time 8 ok
stream time Reports/sets a time stamp to streaming data or not B-22
temp comp Reports/sets temperature compensation on or off B-29
time Reports/sets current time (24-hour time) B-31
up Simulates pressing up pushbutton B-25
zero Sets zero/span valves to zero mode B-29
Table B-1. C-Link Protocol Commands
Command Description Page
Table B-2. Averaging Times
Selection Averaging Time (seconds)
0 1 seconds
12
25
310
420
530
660
790
8 120