C-Link Protocol Commands
Commands
Thermo Electron Corporation Model 48i Instruction Manual B-3
Table B-1 lists the 48i C-Link protocol commands. The interface will
respond to the command strings outlined below.
Table B-1. C-Link Protocol Commands
Command Description Page
addr dns Reports/sets dns address B-32
addr gw Reports/sets default gateway address B-32
addr ip Reports/sets IP address B-32
addr nm Reports/sets netmask address B-33
agc int Reports current AGC intensity B-15
alarm agc intensity
max
Reports/sets AGC intensity alarm maximum value B-11
alarm agc intensity
min
Reports/sets AGC intensity alarm minimum value B-11
alarm bias voltage
max
Reports/sets bias voltage alarm maximum value B-11
alarm bias voltage
min
Reports/sets bias voltage alarm minimum value B-11
alarm chamber
temp max
Reports/sets chamber temperature alarm maximum value B-12
alarm chamber
temp min
Reports/sets chamber temperature alarm minimum value B-12
alarm conc max Reports/sets current CO concentration alarm maximum value B-12
alarm conc min Reports/sets current CO concentration alarm minimum value B-12
alarm internal
temp max
Reports/sets internal temperature alarm maximum value B-13
alarm internal
temp min
Reports/sets internal temperature alarm minimum value B-13
alarm motor speed
max
Reports/sets motor speed alarm maximum value B-13
alarm motor speed
min
Reports/sets motor speed alarm minimum value B-13
alarm pressure
max
Reports/sets pressure alarm maximum value B-13
alarm pressure min Reports/sets pressure alarm minimum value B-14
alarm sample flow
max
Reports/sets sample flow alarm maximum value B-14
alarm sample flow
min
Reports/sets sample flow alarm minimum value B-14
alarm trig conc co Reports/sets current CO concentration alarm warning value B-14
analog iout range Reports analog current output range per channel B-36
To Next Page