C-Link Protocol Commands
Communications Configuration
B-34 Model 48i Instruction Manual Thermo Electron Corporation
These commands enables and disables the DHCP service by either on or off.
Changes to this parameter will only take effect when the analyzer is powered
up. The example below sets the DHCP service on.
Send: set dhcp on
Receive: set dhcp on ok
format
This command reports the current reply termination format. The example
below shows that the reply format is 00, which means reply with no
checksum, according to Table B-8.
Send: format
Receive: format 00
set format format
This command sets the reply termination format, where format is set
according to Table B-8. The example below sets the reply termination
format to checksum.
Send: set format 01
Receive: set format 01 ok
where xxxx = 4 hexadecimal digits that represent the sum of all the
characters (bytes) in the message
host name
This command reports the host name string.
Send: host name
Receive: host name analyzer01
set host name string
This command sets the host name string, where string is 1-13 alphanumeric
characters.
WARNING When DHCP is set to on, the user-supplied addr gw, addr dns,
addr ip, and addr nm parameters are not used.
Table B-8. Reply Termination Formats
Format Reply Termination
00 <CR>
01 <NL> sum xxxx <CR>
To Next Page
Loading...
