3
Learning Center
Set Up the Instrument
Thermo Scientific NanoDrop One User Guide 183
–tap Unpair
device is no longer listed under “Paired Devices” but remains in Available Devices list
–tap Back to return to System settings
–tap Done to close Settings
Set up Ethernet Connection
The instrument Ethernet port can be used to set up a wired connection between the
instrument and a personal computer (or PC). The connected computer can then be used to
store or view data acquired with the NanoDrop One instrument. (NanoDrop One
Viewer software must be installed on the computer.)
Tools needed:
• Standard (straight through) Ethernet cable (CAT5e or newer is recommended)
Set up Ethernet connection
– connect Ethernet cable between Ethernet port on instrument back panel (see image
above) and Ethernet port on computer
Note If the computer is an older model, you may need a crossover Ethernet cable instead.
Most newer model computers are designed to automatically detect and work with both
cable types. However, a straight through cable will provide best performance.
To Next Page
Loading...
