3
Learning Center
Set Up the Instrument
184 NanoDrop One User Guide Thermo Scientific
Set up Wireless Connections
Use Wi-Fi™ to connect the instrument to a remote computer through a wireless local area
network (WLAN). The remote computer can then be used to store or view data acquired with
a NanoDrop One instrument.
Select Wi-Fi network on the instrument
– from instrument Home screen, tap (Settings)
–tap System tab
–tap Wi-Fi (if Wi-Fi is disabled, button in upper right is set to “OFF” and no wireless
networks are listed)
– tap button to enable Wi-Fi and display available Wi-Fi networks
– select remote computer’s Wi-Fi network host and tap Connect (here is an example)
Note To store or view collected data on a connected computer using W-Fi,
NanoDrop One Viewer software must be installed on the remote computer and the
computer must be configured for Wi-Fi data storage. The instrument must also be
connected to the remote computer’s network host and have Wi-Fi enabled.
To Next Page
Loading...
